Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 24
TCS
Microswitch
While the stacker is operating, the material
support always slips further down the more
labels in a stack. The support activates a
microswitch at the bottom end of the stacking
range, which stops the printer.
Assembly/Disassembling
The microswitch (1) can be replaced from the
bottom of the stacker.
1. Unscrew the two slot screws (accessible
from the outside (2)).
2. Detach the plug connector of the
connector cable from the cable tree.
Tools
– Screwdriver, small
Photoelectric switch
The photoelectric switch (3) is positioned
somewhat below the motor in the stacker
housing. It can be disassembled from the
back of the stacker (4) without having to open
the housing.
Assembly/Disassembling
1. Unscrew the Allan key fastening screw
(5) through the recess in the housing.
2. Detach the plug connector of the
connector cable from the cable tree.
Tools
– Allen key size 3
2
1
3
4
5