Specifications
01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 17
TCS
Setting the cutter
Top cutter
1. Loosen the motor attachment (1).
2. Push a feeler gauge (0.5 mm) between
guide and slide block.
3. Turn the crank to the bottom dead
centre (2) and tighten the motor
attachment screws.
4. Turn the crank to the top dead centre.
5. Set the photoelectric switch flag (3) so
that it covers the photoelectric switch
(4). To do this loosen the fastening
screw (5), adjust the position of the flag
and then retighten the screw.
The fastening screw can be accessed
from the outside by a borehole in the
housing.
Top photo: motor fitted
Middle photo: motor removed
At top dead centre the top and bottom
cutters overlap by less than a
centimetre.
The aperture between the two cutters
must be sufficient to allow material to
pass through (6).
Führung
Gleitstein
0,5
Z00530D.cdr
3
4
3
5
5
6
1
1
2
1