Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 11
TCS
Upgrading to type II
Upgrading from type I to type II is only possible under certain conditions.

It is recommended that the following modified parts are fitted:
connecting cable with strain relief (see Fig. 6:)
bottom material guide plate (see Fig. 5:)

It is essential that the modified mounting shaft is fitted along with the
modified material guide plate!
See "Spare parts list" for more information.

All other parts used on the TCS type II are not backwards compatible and
must not be fitted in TCS units of type I!
CAUTION!
Danger of fingers being squeezed!
– Under no circumstances must you fit the additional cross-strut (part 2
in Fig. 4:) in a TCS of type I! A unit that is modified in this way will not
satisfy the safety requirements of the TÜV. Fingers could be squeezed
between the cutter carriages and the cross-strut!
Fig. 4: Constructive modifications of the TCS type II compared with
type I: longer side guides (1); additional cross-strut (2); top
material guide (3, see Fig. 5:); bottom material guide (4); strain
relief (5, see Fig. 6:)

5
4
3
2
1
1