Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 10
TCS
Technical modifications
Desig-
nation
Feature Effective from
none Retaining pins. Top material guide plate not
adjustable. Can be upgraded to Type 1
with modification kit (see Fig. 3:).
10/99
Type I Top material guide plate adjustable by
means of a grub screw. Plexiglass plate
above the material inlet (see Fig. 3:).
Cannot necessarily be upgraded to Type II.
approx. 5/00
Type II
Reinforced bottom material guide plate.
Due to modified mounting shaft (smaller
diameter in center section).
Longer connecting cable with strain relief.
Longer side guides + reinforcing struts at
upper end between the guides.
approx. 5/01 and
serial no.
0285780105-
STAC
Fig. 2: The three different variants of the TCS, resulting from design
modifications aimed at functional optimisation.
Fig. 3: Left side: older TCS version using retaining pins; right side:
version with setting screw (Type I).
Upgrading to type I
Stackers of the older version of the TCS using retaining pins (see Fig. 3:
left) can be upgraded to type I by means of a modification kit. Upgrading is
very simple and offers some advantages, e.g. easier feeding-in of the
material and less noise.

It is strongly recommended that older, type I stackers are upgraded!
For upgrade instructions, please refer to section Retrofitting the type I
material guide.