Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
71
8852 Graphic header
Status A graphics file declared by a Easy Plug #YG command should be
proceeded. The file header doesn´t match the file.
Measure
 The graphics file is possibly faulty. Check the file and replace it if
necessary.
8853 Graphic palette
Status A graphics file declared by a Easy Plug #YG command should be
proceeded. Error reading the graphics palette.
Measure
 The graphics file is possibly faulty. Check the file and replace it if
necessary.
8854 Graphic read
Status A graphics file declared by a Easy Plug #YG command should be
proceeded. Error reading the file.
Measure
 The graphics file is possibly faulty. Check the file and replace it if
necessary.
8856 Free store size
Status By setting parameter SYSTEM PARAMETER > Free store size, a part of the
memory is reserved, which the printer firmware can use if necessary
(dynamic memory allocation). If this memory area is dimensioned too small,
the printer firmware can not work and this error message shows up. One
cause may for example be, that data are supposed to be loaded, whose
size exceeds the reserved memory (e. g. graphics).
Measure
 Enlarging the reserved memory partition, that is increasing the value of
SYSTEM PARAMETER > Free store size.
8857 Wrong mem config
Wrong memory configuration
Status Too much memory requested by parameters. The following parameters
request more or less memory:
•
SYSTEM PARAMETER > Font downl. area
•
SYSTEM PARAMETER > Ram disk size
•
SYSTEM PARAMETER > Free store size
The fault occurs, if the sum of requested memory space exceeds the
amount of available memory.
After error confirmation, the relevant parameters are set back to their
default values. Furthermore, a restart is triggered.
Measure
 Change the settings of the relevant parameters.