Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
66
8301 Bar code data
Status Incorrect bar code data. The bar code data is not permitted for the selected
bar code type.
Measure
 Use data permitted for the bar code type.
8302 Barcode checksum
Status Error during calculation of the bar code check sum.
Measure
 Check transmitted data.
 If the error continues to occur please contact the manufacturer. Send the
transmitted Easy Plug data.
8303 Bar code sample
Status Error during calculation of the bar code sample.
Measure
 Check whether the transmitted data is permitted for the bar code type; if
necessary alter the data.
8304 Bar c. plain-copy
Status Error during integration of the plain-copy line in the bar code sample.
Measure
 Check whether the transmitted data is permitted for the bar code type; if
necessary alter the data.
8305 Bar code print
Status Error during calculation of the bar code print image.
Measure
 Acknowledge by pressing the Online button.
Measure
 Check whether the transmitted data is permitted for the bar code type; if
necessary alter the data.
8306 Plain-copy len.
Status Illegal: bar code plain-copy line has more than 300 characters.
Measure
 Reduce line length.
8307 Readline dist.
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8308 Bar code ratio
Status Illegal bar code ratio.
Measure
 Select another ratio.