Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
65
8110 Unknown char.
Status Character is not included in the character set (character set does not
support all characters).
Measure
 Select another character / character set.
8111 Stream type
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8112 Font not supp.
Status The applied Truetype font is not supported by the system. Text, which uses
this font, is ignored.
Measure
 Use another Truetype font.
8200 Fixfont number
Status Incorrect fix font no.
Measure
 Check fix font no., alter if necessary.
8201 Font downl. full
Status The font download buffer is full.
Measure
 Allocate more memory for the download buffer using the parameter
SYSTEM PARAMETERS > Font downl. area.
 Rename some speedo-fonts on the CompactFlash-Card, you actually don´t
use. All speedo-fonts named fontxxx.spd (xxx = font no.) are being loaded
into the font download buffer while system startup.
 For Details refer to the manual „Cards“, subject section „Using cards“,
paragraph „memory card“.
8202 Font deleted
Status Attempt to access a font, which is no longer available on memory card or
on RAM disk (font was deleted or renamed).
Measure
 Check the label layout. Load the not available font or use another,
available, font.
8300 Bar code corr.
Status Error: a bar code correction factor greater than +/- 25% has been selected.
Measure
 Reduce correction factor.