Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
64
8002 Stream Buffer
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8103 TrueDoc Font
Status Error: font with the number given is not contained in the system.
Measure
 Check font no., if necessary select another font.
8104 Speedo alloc
Status Fault while initializing the speedo fonts.
Measure
 Load firmware new.
 Refer to the service manual, topic section "Firmware".
8105 Load TrueType
Status Damaged font file.
Measure
 Switch printer off and then back on again after thirty seconds.
 Reload font file, if necessary select another font.
8106 Fonttype wrong
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8107 Character set
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8108 Symbol set
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
8109 TT-specifications
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.