Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
62
6205 Write disk
Status Error during writing on RAM disk or memory card.
Measure
 Acknowledge by pressing the Online button.
6206 Read disk
Status Error during reading from RAM disk or memory card.
Measure
 Acknowledge by pressing the Online button.
6207 No file card
Status No CompactFlash-card found.
Measure
 Acknowledge by pressing the Online button.
 Check, if a memory card is inserted.
 If the memory card was inserted after switching on the printer: switch the
printer off and on again.
6208 Drive xx full
Status Writing on drive xx failed, because there is not enough free space.
Measure
 Acknowledge by pressing the Online button.
 Free space on the drive.
6300 Out of memory
Status Not enough free memory available, to load additional print jobs. The job
buffer is completely filled with print jobs.
Measure
 Delete spooler using the parameter SPECIAL FUNCTION > Delete spooler.
6301 Incomplete job
Status The Easy Plug interpreter failed interpreting a certain print job to the end.
The print job has possibly not been terminated by a #Q-command.
Measure
 Check, if the print job is properly terminated with #Q.
6310 Centr. Timeout
Status The Easy Plug command #!Xn triggers a status acknowledgement via
centronics Interface. But the PC dosn´t pick up the supplied data.
Measure
 Check the data line connecting printer and PC.
6311 Centr. Timeout
Status The Easy Plug command #!Xn triggers a status acknowledgement via
centronics Interface. But the PC dosn´t pick up the supplied data.
Measure
 Check the data line connecting printer and PC.