Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
60
6005 Fixfont data
Status Defective fixfonts.
Measure
 Load the firmware new.
 Refer to the service manual, topic section "Firmware".
6006 Speedofont data
Status Defective speedo fonts.
Measure
 Load the firmware new.
 Refer to the service manual, topic section "Firmware".
6007 Print ctrl. stop
Status The print control doesn´t start, what means that the printer doesn´t finish
the initialization phase after switching it on.
Measure
 Read in the service manual, what to do:
 Refer to the service manual, topic section "Firmware" or “Firmware Gen. 3”,
chapter “Error messages”.
6008 MLI Fixfont data
Status Defective fixfonts.
Measure
 Load the firmware new.
 Refer to the service manual, topic section "Firmware".
6009 MLI Speedo data
Status Defective speedo fonts.
Measure
 Load the firmware new.
 Refer to the service manual, topic section "Firmware".
6010 Printengine soft
Status General software error.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors
.
6012 Start next job
Status The message appears at the end of a printjob, if the single job mode
(SYSTEM PARAMETERS > Single job mode) is activated. It indicates, that the next
printjob should be started.
Measure
 Acknowledge by pressing the online button. Start next printjob.