Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
59
6000 Param. incorrect
Status Novram check sum error.

Check the setting of the printhead resistance (parameter
SYSTEM PARAMETER > Head resistance) , before you press the Online button –
possibly the value is faulty.
Measure
 Confirm error by pressing the Online button. All parameters are set back to
the factory settings.
6001 Nov. prog. err.
Status Error during allocation of main memory.
Measure
 Switch printer off and then back on again after 30 sec. If the error message
continues to appear, please contact the manufacturer.
6002 New prog. vers.
Status Occurs after firmware update. The printer hereby reports that new firmware
is available.
Measure
 Confirm by pressing the Online button. All parameters are set back to the
factory settings.
6003 Memory error
Status Error during partitioning of the main memory.
Measure
 Switch printer off and back on again after 30 sec. If the error message
continues to appear, please contact the manufacturer.
6004 Load H8 program
Status Appears, when
a) no valid H8 firmware is loaded
b) after a forced start of the boot loader
Measure Case a)
1. Press the Online button to confirm.
2. Load H8 firmware.
 For details, refer to the service manual, topic section "Firmware", section
"Loading the H8 system".
Case b)
 Press the Online button to confirm.
 For details, refer to the service manual, topic section "Firmware", section
"Loading the Firmware (using boot loader)".