Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
58
5550 Wrong tag type
Status A transponder type was detected, which is not known by the reader – it
cannot be used.
Measure
 Use another transponder type, which is known to the reader.
5551 Max Tags failed
Status The maximum permissible number of invalid labels was reached. This
value is to be set via parameter SYSTEM PARAMETERS > Max Tags To Stop.

Invalid labels are being printed on with diagonal stripes.
Measure
 Find out, why the labels are invalid; put things right.
 Increase the maximum value.
5560 TCS full / cover
Status This message can only appear, if a TCS is applied as peripheral device.
The message shows up, if:
•
the stacker is full
•
the stacker cover is open
Measure
 Empty the stacker, or
 close the cover
5590 Odd hex string
Status A character string was sent to the transponder (Easy Plug command #RFS)
and was ought to be interpreted hexadecimal (use #RFS with parameter
"B"). For this, the character string must consist of an equal number of
characters. This was not the case, what triggered this error message.
Measure
 Send an equal number of characters.
5600 Job without #Q
Status The print job misses the declaration of the print amount (Easy-Plug
command #Q).
Measure
 Insert a #Q command with the print amount.
5601 Job memory full
Status The job memory for Easy-Plug printjobs is full.
Measure
 Reduce the reserved memory for one or more of the following memory
areas:
•
Free store size (SYSTEM PARAMETER > Free store size)
•
RAM disk size (SYSTEM PARAMETER > Ram disk size)
•
Font download size (SYSTEM PARAMETER > Font downl. area)
 If there are already some printjobs in the printer queue: wait until those are
processed.