Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
56
5525 Tag read err
Status The plausibility test of the read data failed. Possible reasons are:
•
The tag is out of reach of the antenna, after it has already been recognized.
•
Noise signals avoid the transmission.
Measure
 Check the system for the mentioned error causes and correct them.
5526 Tag select first
Status A read or write command was given without selecting the transponder at
first.
Measure
 Add a select command before using the read/write command.
5527 Tag RF comm err
Status Transponder and reader are unable to communicate. Possible reasons are:
•
More than one transponder is within reach of the antenna.
•
No transponder is within reach of the antenna.
Measure
 Check the label material feeding; eventually remove paper jam.
5528 EEPROM failure
Status
•
The reader cannot write on the transponder EEPROM.
•
A faulty checksum was detected before writing on the EEPROM.
Measure
 Repeat the writing attempt.
 Try another transponder
5529 Parameter range
Status Faulty address. Transponders of the same type may have memory ranges
of different sizes; according to this, the admissible addresses differ too.
The fault occurs, if a block address targets beyond the address range of the
transponder.
Measure
 Change the address.
 Use a transponder with a wider address range.
5530 Unknown CMD
Status The reader doesn´t support the used command.
Measure
 Change or replace the command.
5531 Protocol length
Status General software error
Measure  Please read the notes in section General software errors
.