Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
54
5300 BLDC EEPROM err.
Status General EEPROM read/write error on the BLDC driver board (AP 5.4 with
internal rewinder).
Measure
 Switch printer off and than on again after 30 seconds. If the status message
continues to appear, change the BLDC board.
5301 BLDC rewinder Ø
Status The stored rewinder diameter on the BLDC driver board is wrong (AP 5.4
with internal rewinder).
Measure
 Acknowledge the status message by pressing the online button. Switch the
printer off and on again to initialize the rewinder.
5500 Unknown
Status General software error
Measure  Please read the notes in section General software errors
.
5501 General
Status General software error
Measure  Please read the notes in section General software errors
.
5502-5551 Messages, which can only occur with RFID option
5502 RFID internal
Status General software error
Measure  Please read the notes in section General software errors
.
5504 No RFID job
Status A print job, which is not declared as RFID printjob, contains RFID-specific
Easy-Plug commands (e. g. #RT, #RFW, …).
RFID printjobs are declared in the #IM command by defining the distance
between label edge and optimum of transponder antenna (parameter "d").
Measure  Modify the print job.
5510 RFID COM timeout
Status Timeout error. There was no communication between reader module and
COM2 in the time slot where it should be performed.
Measure
 Repeat the operation, in the course of which the error occured.
 Check, if the reader module board is connected correctly.
 Check if the reader module board is defective.