Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
53
5204 Appl. Starterror
Status The device received another start signal during printing/applying a label.
Precondition: Parameter APPLICATOR PARA > Start error stop or
DP INTERFACE > Start error stop is set to On.
Measure
 Check the labelling procedure; increase the product distance.
 Set parameter Start error stop to Off.
5205 Applicator gen.
Status General software error
Measure  Please read the notes in section General software errors
.
5206 Applicator resp.
Status Communication with the AI exceeded a given time frame.
Measure
 Switch the printer off and on again after half a minute. If the error still
occurs after several trys, please contact our technical support.
5207 Appl. driver 1
Status Shortcut or overheat at power output 1 of the AI.
Measure
 Check the connections.
5208 Appl. driver 2
Status Shortcut or overheat at power output 2 of the AI.
Measure
 Check the connections.
5209 Appl. driver 3
Status Shortcut or overheat at power output 3 of the AI.
Measure
 Check the connections.
5210 Appl. driver 4
Status Shortcut or overheat at power output 4 of the AI.
Measure
 Check the connections.
5212 Vx.x for AI rec
Status The required AI firmware (version x.x) is not installed.
Measure If the installed AI firmware is older than the required version:
 Acknowledge message. Load AI firmware version x.x.
If the installed AI firmware is newer than the required version:
The message is acknowledged automaticallly.