Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
49
5122 PLC not ready
Situation:
•
The parameter DP INTERFACE > Interface type is set to USI Applicator.
•
Internal inputs are enabled.
Status The connected PLC is not on line.
Measure
 Check if the PLC is powered on.
 Check if the PLC shows any error status.
 Ackknowledge by pressing the Online button.
5123 USI Material low
The error can only occur with an ALX 92x with optional OD control sensor.
Status The outer diameter of the material roll has reached the set minimum value.
Measure
 Insert a new material roll.
 Ackknowledge by pressing the Online button.