Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
48
5100 Printengine lock
Status Printengine error (occurs only at devices with Gen. 3 electronics).
Measure
 Acknowledge by pressing the Online button.
 Switch device off and on again.
If the message continues to appear:
 Contact service technician.
5101 Headadjust error
Status Error during the running of the "Head Alignment" service function.
Measure
 Acknowledge by pressing the Online button.
 Contact service technician.
5102 Dot Defective
Status Defective dot detected during the running of the "Head dot test" service
function.
Measure
 Acknowledge by pressing the Online button.
5120 Home position
Status The applied applicator cannot reach the home position; this can be caused
by an impact from outside (e.g. extending it manually), which has moved
the applicator. In those cases, the stepper motor looses steps and doesn´t
regain its home position.
Preconditions for this error to occur:
•
The parameter DP INTERFACE > Interface type is set to USI Applicator.
•
Internal inputs are enabled.
Measure
 Take care not to move the applicator by force.
 Ackknowledge by pressing the Online button.
5121 Touch down
Status The applied applicator doesn´t reach the Touch Down Position, what
means that it extends completely without reaching any product or other
resistance. .
Preconditions for this error to occur:
•
The parameter DP INTERFACE > Interface type is set to USI Applicator.
•
Internal inputs are enabled.
Measure
 Correct the applicator position. The applicator must reach the product
before it is completely extended.
 Ackknowledge by pressing the Online button.