Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
46
5056 Infeed 2 empty
Status (TT4 only) While initializing, TT4 reports no material in infeed 1.

Precondition for this status message is, that parameter
SYSTEM PARAMETERS > w/wo magazine is set to „with“.
Measure
 Check, if the material in infeed 1 is loaded correctly, respectively if it´s
loaded at all. Acknowledge by pressing the Online button.
5057 Infeed 3 empty
Status (TT4 only) While initializing, TT4 reports no material in infeed 1.

Precondition for this status message is, that parameter
SYSTEM PARAMETERS > w/wo magazine is set to „with“.
Measure
 Check, if the material in infeed 1 is loaded correctly, respectively if it´s
loaded at all. Acknowledge by pressing the Online button.
5058 Infeed 4 empty
Status (TT4 only) While initializing, TT4 reports no material in infeed 1.

Precondition for this status message is, that parameter
SYSTEM PARAMETERS > w/wo magazine is set to „with“.
Measure
 Check, if the material in infeed 1 is loaded correctly, respectively if it´s
loaded at all. Acknowledge by pressing the Online button.
5059 Stacker full
Status (AP 7.t only) This message can only appear if a TCS is applied as
peripheral device. It indicates, that the stacker is full or the protection cover
is opened.
Measure
 Empty stacker
 Close cover
 If the message appears in spite of a closed cover and an emptied stacker,
check the function of lid switch and microswitch.
5060 Stacker full
Status This message can only appear if a TCS is applied as peripheral device. It
indicates, that the stacker is full or the protection cover is opened.
Measure
 Empty stacker
 Close cover
 If the message appears in spite of a closed cover and an emptied stacker,
check the function of lid switch and microswitch.