Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
45
5051-5058 Messages which can only occur with a TT4 printer
5051 Barcode Infeed 1
Status (TT4 only) Error while reading the bar code on the material in infeed 1
Measure
 Check, whether material in infeed 1 is inserted correctly. The bar code must
be in front (in advance direction) on the material bottom. Insert material
correctly, if necessary.
 Check, whether the bar code print is erroneous on material in infeed 1.
Exchange material, if necessary.
5052 Barcode Infeed 2
Status (TT4 only) Error while reading the bar code on the material in infeed 2
Measure
 Check, whether material in infeed 2 is inserted correctly. The bar code must
be in front (in advance direction) on the material bottom. Insert material
correctly, if necessary.
 Check, whether the bar code print is erroneous on material in infeed 2.
Exchange material, if necessary.
5053 Barcode Infeed 3
Status (TT4 only) Error while reading the bar code on the material in infeed 3
Measure
 Check, whether material in infeed 3 is inserted correctly. The bar code must
be in front (in advance direction) on the material bottom. Insert material
correctly, if necessary.
 Check, whether the bar code print is erroneous on material in infeed 3.
Exchange material, if necessary.
5054 Barcode Infeed 4
Status (TT4 only) Error while reading the bar code on the material in infeed 4
Measure
 Check, whether material in infeed 4 is inserted correctly. The bar code must
be in front (in advance direction) on the material bottom. Insert material
correctly, if necessary.
 Check, whether the bar code print is erroneous on material in infeed 4.
Exchange material, if necessary.
5055 Infeed 1 empty
Status (TT4 only) While initializing, TT4 reports no material in infeed 1.

Precondition for this status message is, that parameter
SYSTEM PARAMETERS > w/wo magazine is set to „with“.
Measure
 Check, if the material in infeed 1 is loaded correctly, respectively if it´s
loaded at all. Acknowledge by pressing the Online button.