Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
41
Measure 2
1. Press the Cut button to deactivate the acoustic signal.
2. Press the Feed button in order to acknowledge the status report.
Display: OFFLINE x JOBS
3. Insert a new ribbon.
4. Press the Online button: processing of the job continues, gap LS is
reinitialised.
5009 USI start error
Status This status message can only be triggered with activated parameter
DP INTERFACE > Start error stop. It occurs, if another start signal is given while
printing a label.
Measure
 Acknowledge by pressing the Online button. Press the Feed button
afterwards to proceed with the print job.
5010 Paper jam
Status "Paper jam" shows up, if the automatic paper jam detection was triggered.
Measure
 Acknowledge by pressing the Online button.
 In case of false triggering, increase the setting of the paper jam level.
 See parameter SERVICE FUNCTION > Paper jam level.
5012 Delete H8 loader
Status Error while loading the H8 firmware: the old firmware on the machine could
not be deleted.
Measure
 Acknowledge by pressing the Online button.
 Retry loading the firmware.
 If the error occurs repeatedly, the bootloader must be loaded newly.
5013 Prog H8 loader
Status Error while loading the H8 firmware: the new firmware could not be written.
Measure
 Acknowledge by pressing the Online button.
 Retry loading the firmware.
 If the error occurs repeatedly, the bootloader must be loaded newly.
5014 Power
Measure  Acknowledge by pressing the Online button.