Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
35
3001/3004/3007/3013/3016 Com x Parity
Status Receive error at the RS232 interface COMx (x = [1…5]).
Measure
 Acknowledge by pressing the Online button.
 Check parameter setting at printer (INTERF. PARAM. > COM1 PORT > Parity) and
PC.
 Notes about setting the printer parameters are given in the chapter "Info
Print-outs and Parameters" in the User Manual.
3002/3005/3008/3015/3017 Com x Frame
Status Receive error at the RS232 interface COMx (x = [1…5]).
Measure
 Acknowledge by pressing the Online button.
 Check parameter setting at printer (INTERF. PARAM. > COM1 PORT > Baud rate
and INTERF. PARAM. > COM1 PORT > stop bits) and PC.
 Notes about setting the printer parameters are given in the chapter "Info
Print-outs and Parameters" in the User Manual.
3010 Spooler Overflow
Status Fault which is caused by a faulty handshake at an interface. The
consequence is an overflowing data buffer at the printer, because the host
doesn´t stop to send data to the printer.
Measure
 Acknowledge by pressing the Online button.
 Check the connections of the data line, especially the signal wires
belonging to the handshake.
 Check the interface settings, especially the handshake settings.
3011 Send buffer full
Status The send buffer is full. This error may happen, if the printer status was
requested several times (#!Xn), but the status reply was not read out.
Measure
 Make sure that the status reply is read out.