Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
32
1525 USI not exist
Error level 1
Status The printer is not equipped with a USI board.
Measure
 Modify the printjob.
 Install a USI board.
1526 Can't Off CV
Error level 1
Status Command attempting to turn off barcode validations.
Measure
 Check and modify the commands in the printjob.
1527 Offset illegal
Error level 2
Status RTC command specified a clock offset not supported by this printer
(possibly a negative offset).
Measure
 Correct the command.
1528 Language illegal
Error level 2
Status Language specified by RTC command is not English or German.
Measure
 Correct the command.
1529 Invalid Prn Mode
Error level 1
Status Print modes other than cutter mode are selected (Tear-off, Rewind or Peel-
off modes in ^MM command).
Measure
 Correct the command.
1530 Inc free str mem
Error level 2
Status Not enough free store memory.
Measure
 Increase the value set in SYSTEM PARAMETER > Free store size (at least
2048 Kbytes).
1531 Inc RAM disc
Error level 2
Status Not enough RAM disc.
Measure
 Increase the value set in SYSTEM PARAMETER > Ram disk size (at least
2048 Kbytes).