Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
31
1518 Bad Format: x
Error level 2
Status The graphic format selected is not supported by Avery ZPL Emulation
(Compressed binary and PNG format).
Measure
 Convert graphic into a supported format.
1519 Cmd Init Error
Error level 1
Status General software error.
Measure Read chapter General software errors
 on page 8.
1520 Unsupported Cmd
Error level 1
Status Non critical commands that is not supported by this printer.
Measure
 Check and modify the commands in the printjob.
1521 Unsupported: x
Error level 2
Status Critical commands that is not supported by this printer.
Measure
 Check and modify the commands in the printjob.
1522 Bad Char Set x
Error level 2
Status The character set selected by ^CI command is not supported.
Measure
 Replace the character set by a supported set.
1523 Cmd Parm Error
Error level 1
Status Error encountered while parsing command parameter.
Measure
 Check and modify the commands in the printjob.
1524 d/mm not chg x
Error level 2
Status Command attempting to lower print density assuming a 200 dpi printer.
Measure
 Check and modify the commands in the printjob.