Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
30
1511 Bar Parm Error
Error level 1
Status Parameters to a barcode command is wrong or does not conform with
specs.
Measure
 Modify the bar code command.
1512 Code128 Mode Err
Error level 1
Status Code128 barcode command specifying mode type other than 'AUTO'.
Measure
 Modify the bar code command.
1513 Wrong Mode
Error level 2
Status Coda block barcode command specifying mode type other than 'F'.
Measure
 Modify the bar code command.
1514 ^BX Parm Err.
Error level 2
Status Data Matrix bar code command specified an escape sequence character.
This is not supported in this printer.
Measure
 Modify the bar code command.
1515 Conv to ECC200
Error level 1
Status Data Matrix barcode command specified non ECC200 level. Program is
attempting to convert to ECC200.
Measure
 Modify the bar code command.
1516 Bad Drive: x
Error level 2
Status The drive selected is not a valid drive. (We support only 'R' and 'B').
Measure
 Select a valid drive.
1517 Mask String: x
Error level 2
Status The mask string used in ^SF command is not supported.
Measure
 Modify the print job.