Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
28
1471 Y-Offset
Status The y-position of a layout element (graphics, text, ...) is beyond the label
margin. The element is shifted automatically to the first admissible position
at the correct side of the margin.
Measure
 Check the y-positions of the layout elements and change them, if
necessary.
 Please read the notes in section Easy-Plug errors .
1501-1535 Messages, which can occur in MLI emulation mode
Avery Dennison´s MONARCH LANGUAGE INTERPRETER™(MLI™)
helps you use an Avery Dennison AP 4.4, AP 5.4, 64-xx, ALX 92x, DPM,
PEM or AP 7.t printer which was set up for use with ZIH Corp.´s ZPL II®
1)
.
If you have any questions about using an Avery Dennison printer with these
data streams, please contact Service.
This section lists the error messages that may appear when using the
ZPL II® commands interpreted by the Avery Dennison printer´s MONARCH
LANGUAGE INTERPRETER™.
1501 Unknown MLI Cmd
Error level 1
Status An uninterpretable command was encountered.
Measure
 Check, if the printjob was proceeded correctly. If yes, ignore the message,
if no, modify the printjob.
1502 MLI Hash Error
Error level 1
Status General software error.
Measure Read chapter General software errors
 on page 8.
1503 Filename Too Long
Error level 1
Status Filename is too long.
Measure
 Rename the file with a shorter name.
1)
ZPL II is a registered trademark of ZIH Corp. ZIH Corp. and Avery Dennison (including Paxar
Corporation and its subsidiaries) are not related in any way, and ZIH Corp. has not licensed or
otherwise sponsored MONARCH® printers or Avery Dennison's MONARCH LANGUAGE
INTERPRETER™. MONARCH®, MONARCH LANGUAGE INTERPRETER, MLI are trademarks of
Paxar Americas, Inc. Avery Dennison is a registered trademark of Avery Dennison Corporation.