Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
27
1395 Label too wide
Status A printjob contains an #IM-command which sets the label width to a
measure exceeding the maximum print width. The maximum print width
depends on the printer type.
 Refer to the user manual, topic section „Specifications“ for the maximum
label width.
Measure
 Reduce the label width set by the #IM-command in the concerned print job,
until the label width matches the maximum print width.
 Please read the notes in section Easy-Plug errors .
1396 Label too long
Status Label length setting exceeds the maximum label length. The maximum
label length depends on the memory configuration of the printer.
 The info-printout „Memory Status“ shows among other data the maximum
label length. Read more about info-printouts in topic section „Info-Printouts
and Parameters“.
Measure
 Reduce the label width setting.
 Please read the notes in section Easy-Plug errors .
1397 Label too short
Status The label length defined in the #IM command is smaller than the minimum
admissible length. The label length is set to the minimum value.
Measure
 Correct the length value in the label layout definition.
 Please read the notes in section Easy-Plug errors .
1398 Label too small
Status The label width defined in the #IM command is smaller than the minimum
admissible width. The label width is set to the minimum value.
Measure
 Correct the width value in the label layout definition.
 Please read the notes in section Easy-Plug errors .
1470 X-Offset
Status The x-position of a layout element (graphics, text, ...) is beyond the label
margin. The element is shifted automatically to the first admissible position
at the correct side of the margin.
Measure
 Check the x-positions of the layout elements and change them, if
necessary.
 Please read the notes in section Easy-Plug errors .