Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
20
1173 Y Pos < zero
Status Faulty Easy-Plug code. Value for Y position < zero.
Result The previously set print offset is retained.
Measure
 Check value for Y position for signs.
 Please read the notes in section Easy-Plug errors .
1174 Max width: right
Status Maximum label width, right, reached. Elements such as character, line or
logo do not fit into the physical print format (self-acknowledging)
result Only elements which completely fit into the print format are printed.
Measure
 Alter value for width or position of elements.
 Please read the notes in section Easy-Plug errors .
1175 Max width: left
Status Faulty Easy-Plug code. Maximum label width, left, reached. Elements such
as character, line or logo do not fit into the physical print format (self-
acknowledging)
result Only elements which completely fit into the print format are printed.
Measure
 Alter value for width or position of elements.
 Please read the notes in section Easy-Plug errors .
1176 Max length: top
Status Faulty Easy-Plug code. Maximum label length, top, reached.
Measure
 Correct label layout: Position the drawing elements in a way that they fit on
the label or modify the label length.
 Please read the notes in section Easy-Plug errors .
1177 Max length: bot.
Status Faulty Easy-Plug code. Maximum label length, bottom, reached.
Measure
 Correct label layout: Position the drawing elements in a way that they fit on
the label.
 Please read the notes in section Easy-Plug errors .
1178 x Dots < zero
Status Bit Image:
Measure
 Switch printer off and then back on again after thirty seconds.