Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
19
1140 Line too long
Status Error during conversion from EPT into BIN: permitted line length exceeded.
Measure
 Reduce line length.
1141 Para. incorr. Bl
Status Error during processing of a Bit Image parameter.
Measure
 Acknowledge by pressing the on-line button.
1150 Integer overflow
Status Too many figures for an integer variable.
Measure
 Switch printer off and then back on again after thirty seconds.
 Reduce the number of figures.
1160 String too long
Status A string parameter exceeds the maximum string length of 256 characters
(1024 characters in 2-dimensional bar codes respectively).
Measure
 Reduce the number of characters in the string.
1170 X Pos > width
Status Faulty Easy-Plug code. X position exceeds permitted maximum value.
Result The previously set print offset is retained.
Measure
 Reduce value for X position.
 Please read the notes in section Easy-Plug errors .
1171 X Pos < zero
Status Faulty Easy-Plug code. Value for X position < zero.
Result The previously set print offset is retained.
Measure
 Check value for X position for signs.
 Please read the notes in section Easy-Plug errors .
1172 Y Pos > length
Status Faulty Easy-Plug code. Y position exceeds the label length.
Result The previously set print offset is retained.
Measure
 Reduce value for Y position.
 Select a longer label.
 Please read the notes in section Easy-Plug errors .