Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
18
1124 Logo file
Status General software error
Measure
 Please read the notes in section General software errors .
1125 Delete error
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1126 File creation
Status Faulty Easy-Plug code. A file could not be created. The error may e.g. be
caused by a faulty filename or by too less printer memory.
Measure
 Check all used filenames for length, applied characters, etc. Change the
name if faulty.
 Check the printer for enough memory.
 Please read the notes in section Easy-Plug errors .
1127 File format
Status A file name doesn´t match the (DOS-) filename convention.
Measure
 Check all used filenames for length, applied characters, etc. Change the
name if faulty.
1128 File exists
Status Faulty Easy-Plug code. A file is ought to be loaded into the printer memory
via #DF command. The command was used without adding the parameter
"O" for "Overwrite", but a file already exists under the given name.
Measure
 Rename one of both files or set the parameter "O".
 Please read the notes in section Easy-Plug errors .
1130 Float overflow
Status Number of figures is too high for a floating comma variable.
Measure
 Switch printer off and then back on again after thirty seconds.
 Reduce the number of figures.
1131 Combi overflow
Status Number of figures is too high for a combi variable.
Measure
 Switch printer off and then back on again after thirty seconds.
 Reduce the number of figures.