Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
14
1032 Incorrect char.
Status Parameter contains an invalid character.
Measure
 Check Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .
1033 Uninit flash par
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1034 Uninit restrict
Status A „restricted string“ parameter could not be initialized.
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1035 Uninit combi
Status General software error. A combi parameter could not be initialized.
Measure
 Confirm by pressing the Online button.
 Please read the notes in section General software errors .
1036 Wrong combi para
Status General software error. A combi parameter could not be initialized.
Measure
 Confirm by pressing the Online button.
 Please read the notes in section General software errors .
1037 Software error
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1038 Software error
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .