Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
13
1024 Com. too long
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please pay attention to the notes in chapter General software errors .
1025 Com twice there
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please pay attention to the notes in chapter General software errors .
1026 Comm. w/o. flag
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1027 Uninit parameter
Status Parameter could not be initialised.
Measure
 Acknowledge by pressing the Online button.
1028 Parameter uninit
Status General software error
Measure
 Acknowledge by pressing the Online button.
 Please read the notes in section General software errors .
1029 Param. incorr.
Status Incorrect parameter in the command.
Measure
 Check Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .
1030 Command incorr.
Status Error during the command interpretation.
Measure
 Check Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .
1031 Too many slashes
Status Too many parameters between two slashes.
Measure
 Check Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .