Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
11
1008 Subcomm. incorr.
Status Unknown letter in a subcommand.
Measure
 Check Easy Plug sequence.
1009 Param. tab inc.
Status General software error
Measure
 Acknowledge by pressing the on-line button.
 Please read the notes in section General software errors .
1010 #ER x #Q !
Status One or more illegal commands between #ER and #Q.
Measure
 Check transmitted Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .
1011 #ER missing
Status One or more format commands without leading #ER (self-acknowledging)
Measure
 None. The command is still carried out.
 Please read the notes in section Easy-Plug errors .
1012 #IM x #Q !
Status One or more illegal commands between #IM and #Q.
Measure
 Check Easy Plug sequence.
 Please read the notes in section Easy-Plug errors .
1013 Comm. flag inc.
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1014 Uninit integer
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1015 Uninit float
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .