Service manual

02/10 Rev. 5.04-03 USER + SERVICE MANUAL Status Reports
64-xx – 64-xx Dispenser – DPM – PEM – PM 3000 – ALX 92x – AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t
10
Listing of all Status reports
1000 No new command
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1001 Parameter Table
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1002 Comm. sorting
Status General software error
Measure
 Switch printer off and then back on again after thirty seconds.
 Please read the notes in section General software errors .
1003 Too many slashes
Status General software error
Measure
 Please read the notes in section General software errors .
1004 Slash w/o param.
Status General software error
Measure
 Acknowledge by pressing the on-line button.
 Please read the notes in section General software errors .
1005 2 same commands
Status General software error
Measure
 Acknowledge by pressing the on-line button.
 Please read the notes in section General software errors .
1006 Letter incorrect
Status General software error: self-acknowledging
Measure
 Please read the notes in section General software errors .
1007 Command incorr.
Status Unknown command.
Measure
 Check Easy Plug sequence.