User`s manual

User’s Manual—SNAP™ 700 Printer 45
4.4.4 Selecting the Print Speed
The print speed is normally set in the format. You may override the format
setting and specify the speed you want the printer to run. This is useful if you
have formats that were designed for other AVERY DENNISON printers.
In the Virtual Control Panel, select the Options tab. Click on the arrow in the
Print Speed box to drop down a menu of print speed choices. Click on the
desired choice and click on Apply or Close to set the print speed.
The available choices are:
• Format – use the print speed specified in the format. If the print speed
does not exist in the SNAP 700 printer, it will use the closest print speed
that is not greater. For example, if the format was designed for a 676
printer and calls for 5 ips, the SNAP 700 printer will use 4.5 ips.
• Translate – uses the corresponding speed from the printer specified in the
format. For example, if the format was designed for a 676 printer and
called for 5 ips (the third speed in the printer’s speed list of 3, 4, and 5
ips), the SNAP 700 printer would use 4.5 ips, which is the second speed
in its speed list of 3, 4.5, 6, 7, 8, 10 and 12 ips.
The Translate section has limited application and can
cause unintended operation.
• 3, 4.5, 6, 7, 8, 10 or 12 – selects the desired print speed.
4.4.5 Selecting the Flagging Mode
This selection allows you override the flagging mode specified in the format. It
is set in the same way as the Print Speed.
The available selections are:
• Format – uses the flagging mode specified in the format
• Side-step – This selection is for the High Volume Stacker, which is not
available for the SNAP 700 printer. Do not select this.
• Disabled – Disables flagging. No flagging will be done.
4.4.6 Selecting the Sense Mark Type
This selection allows you to override the sense mark type (none, top through
hole or bottom reflective) selected in the format. Its main purpose is to allow you
to activate the optional Contrast Sensor, since older formats or formats for other
AVERY DENNISON printers will not have the Contrast Sensor type.
This option is set in the same way as Print Speed.
