User`s manual

User’s Manual—SNAP™ 700 Printer 35
4. The voice message will say, “Press Start for Demos.”
5. If you do not want to listen to the demos, press the Voice button.
6. The voice message will respond with, “Press Start to Set Volume.”
7. If you do not want to change the speaker volume, press the Voice button.
8. The printer will say “Returning to Print Mode.” At this time the Option
Menu System is complete and the printer is back to normal operation.
For more information on how to use each of the three possibilities in the Option
Menu System, refer to Sections 3.4.1, Running Test Labels; 3.4.2, Using Voice
Demos; and 3.4.3, Setting / Adjusting Voice Button Volume. Appendix 8
contains a flowchart of the Option Menu System.
3.4.1 Running Test Patterns
Your SNAP 700 printer offers you two Test Patterns to run before you proceed to
production.
Test Pattern 1 (Narrow Setup Test Pattern), is a format designed to run on a 2”
wide fabric. It consisting of a solid line down the middle on the front and back of
the label and a solid line across the web that is exactly 1” from the cut, along with
a 2” wide brick pattern. These lines are helpful in adjusting print position to
compensate for mechanical tolerances in the printer, and the brick pattern can be
used to detect dot out in the head.
Test Pattern 2 (Wide Setup Test Pattern) is similar to Test Pattern 1, except that
it is designed to run on a 5” wide stock.
Test Pattern 3 and 4 (Custom Test Pattern 1 and Custom Test Pattern 2) more
closely resemble actual labels and can be used to make adjustments to the
printhead pressure and contrast (see section 4.1.1 and 4.1.2).
When you have determined which Test Pattern you wish to operate, use the
appropriate procedure.
NOTE: The printer is set up to print the selected label test
format in a very large quantity. You must manually start
and stop the printing to make any necessary adjustments
and to end the test run.
Test Pattern 1
1. To run a test label, press and hold the Voice button about two seconds. The
voice message will say, “Press Start for Test Pattern.”
2. Press the Start / Stop Button. The voice message will say, “Press Start for
Narrow Setup Test Pattern”.
