Specifications

Snap Linear Knife Appendix A  35

Appendix A

The SNAP 700 Printer will need minor alterations to have a Linear Knife

installed. These alterations apply to both a new printer and a field installation.

For new printer installation, see instruction “Installing the Linear Knife” and

“Installing the Stacker on the Linear Knife”.

For field installation, replace the original equipment rotary knife by beginning

below.

NOTE: Avoid personal injury or damage to the electronics in the printer by

turning off the printer and disconnect the power cord.

Removing the Stacker

Remove the stacker as shown. It will be installed later on the Linear Knife.

Unplug the stacker cable from the printer.

There is an outer ring in the stacker

connector that will slide back to release the

cable connection.

Loosen the thumb screw that clamps the

stacker to the mount shafts.

Slide stacker off the mount shafts and set

aside to be installed later.

Note: The two mount shafts are used to

mount the Linear Knife.