User`s manual

User’s Manual—SNAP™ 500 Printer

Installation Procedure – Electrical

1) Facing the back of the Printer, remove the pre-punched material from the

horizontal slot (shown below) in the Mother Board Mounting Plate.

KNOCK OUT PRE-PUNCHED SLOT

2) Assemble Internal Verifier Cable into slot and secure with hardware supplied

on 581129.

INTERNAL VERIFIER CABLE

3) Mount J1 (5 wire, 10 pin connector) to MCB J7. Mount J2 (3 wire, 10 pin

connector) to MCB J11.

4) Assemble External Verifier Lead Connector to mating Connector in internal

cable (Installed in step 2) & mating Connectors to top of Verifier.