User`s manual

94 User’s Manual—SNAP™ 500 Printer
Final Assembly
1. Using the supplied Template, scribe a cutout line on the Rear Cover.
SCRIBE TEMPLATE
SCRIBE AND REMOVE
THIS MATERIAL
2. Remove the material within this scribed line. Drill corners and use
Dremel tool or small saw.
3. Slide Cover onto Printer. The cutout should be over the control plate on
the Sensor. The sensor may require both horizontal and vertical
readjustment to fit below the cutout.
4. Reattach the cover. Reconnect Stacker and Remote Control Panel
connections.
5. When ready to use a sense mark format, program the Sensor per
instructions in Appendix 7.