User`s manual

User’s Manual—SNAP™ 500 Printer

Installation Procedure, Rear Assembly

1. Assemble Sensor Mounting Bracket to Sensor body with (2) 8-32 x ¼

Button Head Screws.

SENSOR

4X 8-32 X 1/4

BUTTON HEAD SCREW

SENSOR MOUNT BRACKET

MCB POWER CABLE CONNECTOR

2. Remove (2) plastic Jam Nuts from Sensor, slide over ends of “Y” cable

and secure with (2) 7/32 “E” Clips.

3. Insert the threaded Plastic Nuts into the Sensor receptacles, firmly

seating the Fiber Optic Cable ends and tighten the Plastic Nuts.

7/32 E-RING

FIBER OPTIC CABLE END ("Y" END)

PLASTIC NUT

SENSOR

4. Assemble the Sensor / Bracket / Lead assembly to the Upright Frame

using (2) Pem Nuts directly to the right of the Speaker. Use 8-32 x ¼

Button Head Screws supplied with kit.