User`s manual

User’s Manual—SNAP™ 500 Printer 91
7. Slide the square portion of the “L” bracket through the newly created
hole in the Front Cover and the pickup tube into the slot in the Web
Guide Shaft between the guides.
FIBER OPTIC CABLE
SLOT IN FRONT COVER
8. Insert the Threaded Shaft through the hole in the end of the “L” bracket
and screw it into the Web Guide Shaft until the E-Ring groove is exposed.
Assemble the 3/16 “E” Clip.
THREADED SHAFT
E-RING GROOVE
9. Slide the Bronze Bearing over the end of the Threaded Shaft and in to the
hole in the “L” Bracket.
10. Assemble the Plastic Knob and tighten the Set Screw. Maintain a
minimum of horizontal travel of the shaft in the “L” bracket hole but the
knob must turn freely. This completes the Front Assembly.
WEB GUIDE SHAFT
PLASTIC KNOB
THREADED SHAFT
BRONZE BEARING
"L" BRACKET