User`s manual

User’s Manual—SNAP™ 500 Printer

Sensor Installation

1. Assemble the Sensor / Harness Assembly into the slot in the Mounting

Block, flush with the top and with the Harness in the slot to the flat end

of the Block. Secure with 4-40 x 3/16 Pan Head Screw.

2. Assemble to Upright Frame with Harness passing through the

rectangular hole in the Upright Frame and secure with 8-32 x 3/8 Cap

Screw from the Back of the Frame.

SENSOR

4-40 X 3/16 PAN HEAD SCREW

8-32 X 3/8 CAP SCREW

3. Connect the Harness to MCB Board at Connection labeled “Optional

Bottom Reflective”.

OPTIONAL BOTTOM

REFLECTIVE