User`s manual

User’s Manual—SNAP™ 500 Printer 79
4) The voltage selector switch is found on the side of the power supply facing the
MCB. See the picture below. To access the switch, it may be necessary to
remove the mounting screws and carefully move the power supply away
from the MCB. There are four mounting screws, two above the supply and
two below. Be careful not to put excessive strain on the power supply cables.
5) Using a small, flat-blade screwdriver, move the switch so that the correct line
(mains) voltage shows in the window. If necessary, re-mount the power
supply to the frame. (Make sure the power switch on the power supply is in
the ON (1) position and the power cord is securely inserted in the appliance
coupler.)
6) Re-assemble the cover on the printer.
7) Connect the power cord to the printer.
Power Supply
Voltage Selector Switch