User`s manual

78 User’s Manual—SNAP™ 500 Printer
1.2 Reconfiguring the Internal Power Supply
Check the fuse label on the back cover of the printer. If the fuse label has the
warning shown below, you must perform the following procedure to reconfigure
the internal power supply to 115V or 230V.
NOTE: If the printer has the mark on the back of the
printer near the AC entry, you do not need to reconfigure
the internal power supply.
FUSE WARNING
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, SHOCK OR
ELECTRICAL HAZARD. USE ONLY 250VAC FUSES WITH RATINGS AS
NOTED BELOW. DO NOT INTERCHANGE FUSES.
MACHINE VOLTAGE
(DETERMINED BY FUSE DRAWER
ORIENTATION INTERNAL TO AC ENTRY)
90-132VAC
50-60Hz
180-265VAC
50-60Hz
MAINS PROTECTION
(INTERNAL TO AC ENTRY)
10.0 A 250V
TIME DELAY
1/4 X 1 1/4
FUSE (ONE)
6.0 A 250V
TIME DELAY
5 X 20mm
FUSE (TWO)
WARNING - INTERNAL CHANGES ARE REQUIRED
WHEN CHANGING THE MAINS VOLTAGE. REFER TO
THE USER'S MANUAL FOR INFORMATION AND
INSTRUCTIONS
WARNING: The following procedure requires internal
access to the printer. If the instructions are not followed
exactly, damage to the printer or personal injury or death
may occur. This procedure should only be performed by a
qualified service technician.
1) Unplug the power cord from the back of the printer. Do not reconnect the
power cord until the procedure is complete.
2) Remove the back cover of the printer.
3) Locate the power supply as shown in the picture below.

