User`s manual

User’s Manual—SNAP™ 500 Printer 15
• The Tape Arbor holds the tape supply roll. By rotating the outer knob
clockwise or counterclockwise, you can adjust the Tape Arbor to
accommodate tapes ranging from ½ inch - 2 ¼ inches (12.7 mm - 57.2 mm)
wide.
• The Tape or Web Guide is adjusted by rotating the black knob.
• The Upper and Lower Print Stations are equipped with knobs for adjusting
print head pressure and print density to control the print quality.
• The Upper and Lower Ink Arbors are spring loaded, allowing them to open
up and self center the ink cores to each other. They accommodate ink rolls
ranging from 1 inch - 2 ½ inches with Inch Adapter or from 25 mm – 60 mm
with the Metric Adapter.
• A Rotary Knife Assembly is supplied with the printer. For applications
utilizing woven tapes, a Sonic Knife accessory option providing ultrasonic
cutting and sealing is available.
• The Stacker collects the finished, printed labels. You can adjust it to
accommodate a variety of label tapes and short or long labels. Once the
stacker reaches the bottom, the printer will stop, indicate the stacker is full,
and allow you to remove the labels.
• The Control Panel with buttons and LED’s indicate printer status and
information about specific jobs.
WARNING: This is a class A product. In a domestic
environment this product may cause radio interference in
which case the user may be required to take adequate
measures.
