User`s manual

User’s Manual—SNAP™ 500 Adidas Printer

1. Press the Voice button. A message will play that describes the problem.

2. The problem will be displayed in the Printer Status box on the Virtual

Control Panel in PCMate Platinum. See section 8.0 for a description of the

Virtual Control Panel.

3. The problem will be displayed on the Remote Front Panel option, if it is

installed. See section 7.0 for a description of the Remote Front Panel.

Correct the problem and press the Start Button to start printing again.

NOTE: If the error condition no longer exists, the printer

will start. It is not necessary to press the Start button

twice as is required with previous AVERY DENNISON

printer models. If the error continues to recur, contact

your local AVERY DENNISON representative.

3.3.4 End of Day

When the printer finishes printing all the print jobs that have been sent, it will

stop with a few labels left to print. This allows you to send another next print job

and print it without wasting tape and ink. The Data light will flash to indicate

this condition.

When this occurs, you may send another print job. The printer will start up

automatically.

If you are finished for the day or you need to change tape or ink for the next

print job, press the Start Button. The printer will print the last few labels of the

last print job. You can then turn off the printer or change the tape and ink for the

next print job.

3.3.5 Clearing Print Jobs

If you have sent print jobs to the printer and do not want to print the labels, press

and hold both the Start/Stop and Voice buttons simultaneously. After about 2

seconds, the printer will say “Clearing Current Batch.” If there is only one print

job, the Data light will go out.

If there are more than one print job and you only want to clear the current one,

release the buttons.

If there are more than one print job and you want to clear them all, continue to

hold the buttons until the printer says, “Clearing All Batches.”

3.3.6 Using Pre-Printed Tape

When using pre-printed tape, the printer must detect a sense mark on the tape in

order to print in the proper place. There a three options for detecting the sense

mark:

