Service manual

User / Service Manual Power Stacker
10/06 Rev. 1.09 5
Assembling the Power Stacker
The power stacker is disassembled in the box when you receive it . Before you can use it you
have to assemble the platform !
Move the platform – the plastic part in front has to show to the printer side – on the two axles
coming out of the cover of the power stacker. Move it against the front plate. The axles will
show around 1 mm out of the platform.
Then clip the lock washer to the two axles (as shown on the pictures). The power stacker is
now ready for use with the TDI.
Attention: Please check if the security cover is mounted to the guiding axle (see picture)
of the media guiding.
axles