Service manual

User / Service Manual Power Stacker

10/06 Rev. 1.09 21

Stepper motor

The stepper motor – if mounted to the power stacker – is an assembly and can not be

removed separately (motor and threading axle).

Assembly is like described in the TDI manual (platform).

• remove rear cover

• remove board and carrier

• disassemble platform mechanic

• open lower plate

• remove nut from thread axle

• remove platform block

• open motor screw (2) and remove

motor together with axle

• clean new motor and axle with

Aceton

• glue motor and axle together with

Loctite 648 – and assemble immediate

• position hexagonal nut around 20 mm

from the end of the axle

• move mechanic in vertical position and

press the threading axle down

• the glue is ready after 30 minutes – but

the mechanic can be assembled immediate

min. 20 mm

glue with

oct

press