Service manual

Using Scripts 7-3
Downloading a Script
Follow these instructions to download a script from the MS DOS prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to
accept a script. From the Main Menu select Scripts, then follow these steps.
1. Press  or  until you see Load Script.
2. Press ENTER to enable the printer’s script communication mode.
Note: Only one script can be loaded in the printer at a time.
When downloading a script, if you receive an error:
 Check the available flash memory. See "Checking Available Flash Memory" in
Chapter 6 for more information.
 Format flash memory. See "Formatting Flash Memory" in Chapter 6 for more
information.
After downloading a script, if the script does not appear to be loaded, try formatting flash
memory and download the script again.
SCRIPTS
← Load Script →
ENTER BACK