Service manual

6-10 Operator's Handbook
Using Flash Memory
The flash memory options are in the table below.
Option Choices Default
Format Flash No/Yes No
Unused Flash NA NA
Pack Flash No/Yes No
Formatting Flash Memory
Before storing packets in flash memory, downloading a script, or updating the printer's
firmware, you must format the flash memory. Formatting flash memory is only
required once during initial printer setup.
Note: When you format flash memory, the script and any downloaded TrueType® fonts
saved in the printer's flash memory are deleted and must be resent to the printer.
To format flash memory, from the Main Menu, select Setup. Then, follow these steps.
1. Press  or  until you see Flash Memory.
2. Press SELECT to highlight the flash memory options. The current setting is shown.
3. Press  or  until you see Format Flash, then press ENTER.
4. Press  or  until you see Yes, then press ENTER.
The printer's flash memory is cleared and reformatted. This process may take several
minutes. The printer reboots automatically after formatting flash memory. You need to
resend any fonts you want to use to flash memory again. You return to the Home/Online
screen.
SETUP
← Flash Memory →
SELECT BACK
FLASH MEMORY
Are you sure?
← Yes →
ENTER BACK
FLASH MEMORY
← Format Flash →
ENTER BACK
FLASH MEMORY
Format Flash
← Yes →
ENTER BACK