Service manual

Setting Defaults 6-9
Using Flash Storage
Packets (formats, fonts, graphics) stored in flash memory are saved when the printer is
turned off.
Note: You must format flash memory before enabling this option. Formatting flash
memory is only required once during initial printer setup.
To change the setting, from the Main Menu, select Setup, then Defaults. Then, follow
these steps.
1. Press  until you see Flash Storage.
2. Press CHANGE to highlight the flash storage options. The current setting is shown.
3. Press  or  to scroll through the flash storage options
4. When you see the flash storage setting you need, press SET to save the change.
Press CANCEL to leave the flash storage setting unchanged.
5. Press BACK until you return to the Home/Online screen.
DEFAULTS
← Flash Storage →
Disabled
CHANGE BAC
K
DEFAULTS
Flash Storage
Disabled →
SET CANCE
L
DEFAULTS
← Flash Storage →
Disabled
CHANGE BAC
K